Advantech-DLoG DLT-V8310 - Network Adapter (10;100;1000)

Serial interfaces
Advantech-DLoG DLT-V83 Series Manual V1.31 Page 123 of 178
11.3. Network adapter (10/100/1000)
The DLT-V83 is equipped with a 10/100/1000 Mbit network adapter with
10/100/1000 Mbit per second.
This adapter can be accessed via the bottom of the device and offers an RJ45
connection jack.
The RJ45 connection port has two integrated status LEDs and are assigned as follows:
Fig. 11.1: RJ45 network port
Left LED (green)
Right LED (orange):
LED off: no connection or 10 MBit
LED off: no activity
LED on: Connection with 100 or
1000 MBit
LED flashing: Activity
Problems with data transmission via LAN/Ethernet
If problems occur during data transmission over LAN/Ethernet (e.g. data is lost or not
detected), the cause of these problems may be a cable which is too long. Depending on
the cable layout and interference from the environment, it may be impossible to use the
cable length of 100 m given in the specification (IEEE 802.3 standard). The solution
here is the use of a shorter cable.