Mounting (mechanical and electrical)
Advantech-DLoG DLT-V83 Series Manual V1.31 Page 79 of 178
7.8. Attaching the cable cover
Before commissioning the DLT-V83, the associated cable cover must be attached. The
protection class/category of the DLT-V83 is only ensured if the cable cover is properly
installed.
WARNING
Hazardous voltage, electric shock from contact with live parts.
Only qualified skilled personnel may install the strain relief and the cable cover to
the DLT-V83 industrial PC
NOTICE: Physical damage
Improper installation can lead to liquid penetrating into the DLT-V83 during
running operation. This results in a risk of short-circuit, corrosion, and wear.
7.8.1. Overview of mounting steps
− All cables that are connected to the DLT-V83 must be fit with the right cable
grommets and inserted in the cable outlets of the strain relief rail.
− The cables are secured to the strain relief rail with cable clips. This prevents the
cables from being loosened at the connection points when too much force is exerted
(e.g. during scanning).
− Unused cable entry holes for the strain relief rail must be closed off with dummy
grommets.
− The Advantech-DLoG cable cover must then be secured to the DLT-V83.
To Next Page
Loading...
