R3131 Spectrum Analyzer Operation Manual
APPENDIX 1 ERROR MESSAGE
A1-3*
Error No. Error Message Description
300 Printer is not ready.
Pls check a printer
setting.
Cannot print.
Please check the printer settings.
301 Printer cable problem.
Pls check a cable or
connection.
There is a problem with the printer cable.
Please check the cable connection.
302 Printer is not active. The printer is not enabled
303 Printer is busy. The printer is currently being used.
800 TG output signal is not detected. TG output signals cannot be detected.
801 TG Freq Adjust failure.
Pls report to qualified
service person.
Automatic TG frequency adjustments cannot be
performed.
Please contact qualified service personnel for
repair information.
802 TG Unleveled.
Pls report to qualified
service person.
An abnormal TG level is detected.
Please contact qualified service personnel for
repair information.
803 Normalize buffer full. There is not enough memory to store the normali-
zation data.
Aug 28/98
To Next Page
Loading...
Need help?
General
