REMOTE OPERATION CARRIER FREQUENCY COMMANDS
4-36
[SOURce]:FREQuency:PHASe:OPTimisation
Description: Sets the phase noise performance.
Parameters: <CPD>
Valid values: LTEN less than 10 kHz: optimizes phase noise less than 10 kHz away from carrier
(gives faster synthesizer settling)
GTEN greater than 10 kHz: optimizes phase noise more than 10 kHz away from
carrier (gives slower synthesizer settling)
*RST sets: GTEN
[SOURce]:FREQuency:PHASe:OPTimisation?
Description: Queries the phase noise setting.
Parameters: None
Response: <CRD>
Returned values: LTEN | GTEN
[SOURce]:FREQuency:PHASe:REFerence
Description: Sets the current carrier frequency phase as a zero reference.
Parameters: None
[SOURce]:FREQuency:PHASe:REFerence?
Description: Queries the carrier frequency’s phase relative to the zero reference.
Parameters: None
Response: <NR2>
Returned values: Degrees
To Next Page
