© Agilent Technologies 1989–2002 Agilent 3070 / 79000 Site Preparation 2
:
Radiated Immunity
When subjected to high RFI fields (greater than 1 V/m),
reduced performance may be experienced when making
low-level analog measurements.
Overvoltage Category
AC Power Overvoltage Category: CAT III
Pollution Degree for Agilent 3070 / 79000
Systems
Pollution Degree 2
Insulation Rating for Wires Connected to Agilent
3070 / 79000 Systems
Use only external wiring with insulation rated for the
maximum voltage (Vrms, Vpk or Vdc) and temperature
to which the wire may be subjected in a fault condition.
Example: The system is connected to a source whose
output is set for 50 Vrms. The source could be set for as
high as 300 Vrms, intentionally or unintentionally.
Therefore, the external wiring connected between this
source and the system must be rated for 300 Vrms.
Acoustic Level for Agilent 3070 / 79000 Systems
LpA = 69dB
am Arbeitsplatz (operator’s position)
normaler Betrieb nach EN27779: 1991
Acknowledgements
The XWD i/o and GIF output routines are derived from
Jef Poskanzer’s PBMplus package:
© Copyright by Jef Poskanzer 1989
HP is a registered trademark of Hewlett-Packard
Company.
To Next Page
Loading...
Need help?
General
