Agilent 4155C/4156C User’s Guide Vol.1, Edition 11 3-17
Connecting to Network
If You Use a HP-UX System
Setting Up HP-UX System
To use a network file system and a remote printer on the HP-UX system, contact the
HP-UX system administrator of your site, and request the following setup. The
setup should be performed by the system administrator.
• To register your user account in the system (if you have not had an account)
For the user ID and group ID, a numeric value from 1 to 32767 is available.
• To add a printer (if no printer has been registered)
For the printer name, a maximum 15 alphanumeric characters is available. The
first character must be a letter of the alphabet.
• To enable NFS server and export a directory to the 4155C/4156C
Host name and IP address of the 4155C/4156C are required. Previously acquire
them from the network administrator.
Previously decide the name, owner, and permission of the directory to export.
For the name, a maximum 58 alphanumeric characters including / is available.
Also, acquire the following parameters from the system administrator. They are
required to set up the 4155C/4156C.
• User ID and group ID registered in the system
• IP address of the print server
• Name of the printer registered in the system
• IP address of the NFS server
• Full path name of the directory exported to the 4155C/4156C
To Next Page
Loading...
Need help?
General
