Agilent 4155C/4156C User’s Guide Vol.1, Edition 11 3-35
Connecting to Network
If You Use a Windows PC
Setting Up NFS Server
This section describes how to set up the NFS server using the Microsoft Windows
Services for UNIX software. Before starting the procedure, set up the network of the
computer as described in “Setting Up Network for Windows XP” on page 3-21,
“Setting Up Network for Windows 2000” on page 3-25, or “Setting Up Network for
Windows NT” on page 3-30.
This section provides setup procedures using the Services for UNIX 3.5 software.
Perform step 1 to step 9 to set up the NFS server.
Perform step 10 to export a network file system.
Table 3-9 Check List of Setting up NFS Server
Steps Summary
Step 1. Preparation You add Windows logon accounts, and
create password file and group file.
a
a. The password file and group file are used for the user mapping between
a NFS server and a NFS client.
Step 2. Installation You install Services for UNIX.
Step 3. Server for NFS You set up Server for NFS menu.
Step 4. Group Registration You register groups.
Step 5. User Registration You register users.
Step 6. User Mapping Configuration You specify password file and group file.
Step 7. User Name Mapping You set user mapping.
Step 8. Group Name Mapping You set group mapping.
Step 9. Map Maintenance You save user name mapping data.
Step 10. Export (Windows Explorer) You export a network file system.
To Next Page
Loading...
Need help?
General
