3-30 Agilent 4155C/4156C User’s Guide Vol.1, Edition 11
Connecting to Network
If You Use a Windows PC
Setting Up Network for Windows NT
NOTE If your computer has already been on the network, ignore this section. Just check the
following network parameters.
• Computer name
• IP address of the computer
• IP address of the gateway (optional)
• Subnet mask (optional)
You can check these values by executing the hostname command and the ipconfig
command using the Command Prompt.
This section describes how to set up the network of the computer.
Table 3-7 Check List of Network Setup
Steps Summary
Step 1. Preparation You set up the computer.
Step 2. Network Identification You check the network identification.
Step 3. Network Protocols You set the network protocol.
Step 4. TCP/IP Properties You set up the TCP/IP properties.
Step 5. Network Connection Check You check the network connection.
To Next Page
Loading...
Need help?
General
