Agilent 4155C/4156C User’s Guide Vol.1, Edition 11 4-23
File Operations
Backing Up a Diskette
Backing Up a Diskette
1. Press System key.
2. Select FILER softkey to display the SYSTEM: FILER screen.
3. Move the pointer to the DISK field.
4. Select FLOPPY softkey.
5. Select DISK OPERATION softkey to display the setup fields.
6. In the DISK OPERATION field, select DISK COPY softkey.
7. Insert the source diskette, select EXECUTE softkey, then select one of the
following:
• YES softkey to execute the disk copy.
• NO softkey to cancel the disk copy.
8. After the target diskette message is displayed, remove the source diskette and
insert an initialized target diskette. The target and source diskettes must be the
same format and size. Select:
• YES softkey to execute the disk copy.
• NO softkey to cancel the disk copy.
The PROGRESS STATUS field shows what percentage of the disk copy is
complete.
The internal memory capacity may not be sufficient to perform the entire disk
copy. If so, swap the source and target disks according to the on-screen
instructions.
9. Select EXIT softkey.
To Next Page
Loading...
Need help?
General
