Agilent Technologies 41501B User Manual

Agilent 4155C/4156C User’s Guide Vol.1, Edition 11 7-5
Initial Settings
Default Initial Settings
Default Initial Settings
When you turn on the 4155C/4156C without a diskette, the 4155C/4156C is set the
default initial settings after finishing the power on test.
The default initial settings, except for system screen group, are also set by selecting
DEFAULT MEASURE SETUP secondary softkey in the MEASUREMENT MODE
field on the CHANNELS: CHANNEL DEFINITION screen. The default initial
settings are as follows:
Measurement Units
Measurement units that are verified as operating normally are turned on and set to
the idle state.
Setup items of setup and result screens
These items are set to the default initial settings whenever power is applied or *RST
command is sent, except for the following items, which keep the same value that
they had before *RST or before power was turned off.
• SYSTEM: MISCELLANEOUS screen
• 4155 (or 4156) is System Controller or not
•GPIB Address
• Power Line Frequency
• Screen Save
•Network Setup
• Network Printer Setup
• Network Drive Setup
• User comment field
The default initial settings for USER COMMENT fields of the MEASURE
screen group and STRESS screen group are blank.

Agilent Technologies 41501B Specifications

General

Brand	Agilent Technologies
Model	41501B
Category	Measuring Instruments
Language	English