Chapter 9 Troubleshooting and Maintenance
Troubleshooting the Agilent 5530
Getting Started Guide 9-3
9
No sensor readings. Make sure sensors are properly connected
and Automatic Compensation is selected on
the Set Up Environmental Compensation
screen.
Record button does not work. If using the remote control unit, make sure
the cable is connected properly.
Loss of beam strength before end
of travel path.
Check the alignment of the optics and laser
head.
Clean the optics if necessary. See
“Maintaining the optics” in this chapter for
instructions.
Table 9-1. Problems and Solutions (Continued)
Problem Solution
To Next Page
Loading...
