Chapter 5 Setting Up the Software for a Measurement
Introduction
5-2 Getting Started Guide
5
Introduction
The laser is controlled and the measurements you make are recorded and
analyzed by the Agilent 10747F Metrology Software installed on your
personal computer (PC). The software performs three major functions:
• setting up the software for the laser head, optics, and measurement
type
• making the measurement and collecting data
• analyzing and outputting the results of the measurements, including
transferring the data to a spreadsheet
This chapter covers the first function; chapters 6 and 7 cover the second
and third. Figure 5-1 provides an overview of the metrology software
screens.
The specific instructions required to use the software to make a
measurement are presented in the Agilent 5530 Dynamic Calibrator
Measurements Reference Guide.
To Next Page
Loading...
Need help?
General
