Chapter 4 Using the Agilent 5530 for the First Time
Task 1: Assembling and Connecting Components
Getting Started Guide 4-3
4
Task 1: Assembling and Connecting
Components
To set up the hardware for this tutorial, follow these steps:
1 Print the measurement template provided on page 4-21.
NOTE
Be sure that you do not change the size of the drawing when you print it.
The page size is 8.5” x 11 inches.
2 Place the copy of the measurement template on your work surface. Then
place the straightedge on top of it along the line indicated.
3 Place the laser head on the measurement template so that its two front
feet are on the circles on the template.
Make sure the straightedge extends at least 225 mm (9 inches) in front of
the laser head.
4 Connect and turn on the system by following instructions in Chapter 3,
“Installing the Software and Connecting Components.”
NOTE
You will not be using the sensors for this tutorial.
5 Assemble the linear interferometer as shown in Figure 4-2.
The arrows on the interferometer point to the locations of the reference
and measurement mirrors.
To Next Page
Loading...
Need help?
General
