Agilent Technologies 7890B - Waking the GC from Sleep

118 Operation Manual
7 Resource Conservation
To Wake the GC Now
If the GC is asleep, you can wake it up as follows:
1 Press [Clock Table], select to Instrument Schedule, then press
[Enter].
2 Select the desired wake choice, then press [Enter].
• Wake up now (restore method). Exit sleep mode by loading
the last active method used before going to sleep.
• Wake up now (WAKE method). Exit sleep mode by loading
the WAKE method.
• Run Condition, Wake (current). Exit sleep mode by running
the condition method. When the CONDITION method
ends, the GC loads the last active method used before
going to sleep.
• Run Condition, Wake up (WAKE). Exit sleep mode by
running the condition method. When the CONDITION
method ends, the GC loads the wake method.