Agilent Technologies 7890B - Setting GC Time and Date

176 Operation Manual
10 Configuration
Time
Press [Time] to open this function. The first line always
displays the current date and time, and the last line always
displays a stopwatch. The two middle lines vary:
Between runs Show last and next (calculated) run times.
During a run Show time elapsed and time remaining in the
run.
During Post Run Show last run time and remaining Post Run
time.
To set time and date
1 Press [Config][Time].
2 Select Time zone (hhmm) and enter the local time offset
from GMT using a 24 hour format.
3 Select Time (hhmm) and enter the local time.
4 Select Date (ddmmyy) and enter the date.
To use the stopwatch
1 Press [Time].
2 Scroll to the time= line.
3 To begin the timed period press [Enter].
4 To stop the timed period press [Enter].
5 Press [Clear] to reset the stopwatch.