Operating Basics 2
Operation Manual 17
Instrument Control
The Agilent 7890B GC is typically controlled by an attached
data system such as Agilent OpenLAB CDS. Alternately, the
GC can be controlled entirely from its keypad, with output
data being sent to an attached integrator for report
generation.
Agilent data system users – Please refer to the online help
included in the Agilent data system for details on how to
load, run, or create methods and sequences using the data
system.
Standalone GC users – If you are running your GC without
an attached data system, see the following for details on
loading methods and sequences from the keypad:
• “To load a method”
• “To load a stored sequence”
For details on running methods and sequences from the
keypad see:
• “To manually inject a sample with a syringe and start a
run”
• “To run a method to process a single ALS sample”
• “To start running a sequence”
For details on how to create methods and sequences using
the GC keypad, see “Methods and Sequences”.
To Next Page
Loading...
Need help?
General
