52 Operation Manual
5 Running a Method or a Sequence from the Keypad
To resume a paused sequence
1 Press [Seq Control].
2 Scroll to Resume sequence and press [Enter].
The sequence resumes with the next sample.
To stop a running sequence
1 Press [Seq Control].
2 Scroll to Stop sequence and press [Enter].
The sequence stops at the end of the currently running
subsequence unless [Seq] > Repeat sequence is On. The
sampler tray halts immediately. A stopped sequence can
only be restarted from the beginning.
To resume a stopped sequence
1 Press [Seq Control].
2 Scroll to Resume sequence and press [Enter].
The sequence restarts from the beginning of the sequence.
Aborting a sequence
When a sequence is aborted, it stops immediately without
waiting for the current run to finish.
The following will cause a sequence to abort:
• The [Stop] key is pressed.
• A sampler error occurs, producing an error message.
• The GC detects a configuration mismatch during a method
load.
• A running sequence tries to load a method that doesn’t
exist.
• The sampler is turned off. You can correct the problem
and then resume the sequence. The aborted sample run
will be repeated.
To resume an aborted sequence
1 Correct the problem. (See "Aborting a sequence".)
2 Press [Seq Control].
3 Scroll to Resume sequence and press [Enter].
The aborted sample run will be repeated.
To Next Page
Loading...
Need help?
General
