Configuration 10
Operation Manual 151
Column #
Length The length, in meters, of a capillary column. Enter 0
for a packed column or if the length is not known.
Diameter The inside diameter, in millimeters, of a capillary
column. Enter 0 for a packed column.
Film thickness The thickness, in microns, of the stationary
phase for capillary columns.
Inlet Identifies the source of gas for the column.
Outlet Identifies the device into which the column effluent
flows.
Thermal zone Identifies the device that controls the
temperature of the column.
In_Segment Length The length, in meters, of the In Segment
of a composite column. Enter 0 to disable. See “Composite
Columns” on page 160.
Out_Segment Length The length, in meters, of the Out
Segment of a composite column. Enter 0 to disable. See
“Composite Columns” on page 160.
Segment 2 Length The length, in meters, of the Segment 2 of
a composite column. Enter 0 to disable. See “Composite
Columns” on page 160.
Column ID lock Set whether the column dimensions can be
set using the keyboard or only through an optional barcode
scanner accessory. When locked, the keyboard cannot change
column dimensions, and an Agilent data system will not
overwrite column configuration data. When locked, a method
will use the scanned column configuration.
Scan column barcodes If using an optional barcode scanner
accessory, select to input column configuration data by
scanning it. See “Using the Optional Barcode Reader” on
page 182.
To Next Page
Loading...
Need help?
General
