Configuration 10
Operation Manual 175
Status
The [Status] key has two tables associated with it. You switch
between them by pressing the key.
The Ready/Not Ready status table
This table lists parameters that are Not Ready or gives you a
Ready for Injection display. If there are any faults, warnings, or
method mismatches present, they are displayed here.
The setpoint status table
This table lists setpoints compiled from the active parameter
lists on the instrument. This is a quick way to view active
setpoints during a run without having to open multiple lists.
To configure the setpoint status table
You can change the order of the list. You might want the
three most important setpoints to appear in the window
when you open the table.
1 Press [Config][Status].
2 Scroll to the setpoint that should appear first and press
[Enter]. This setpoint will now appear at the top of the
list.
3 Scroll to the setpoint that should appear second and
press [Enter]. This setpoint will now be the second item
on the list.
4 And so on, until the list is in the order you wish.
To Next Page
Loading...
Need help?
General
