140 Operation Manual
10 Configuration
About Configuration
Configuration is a two- part process for most GC accessory
devices that require power and/or communication resources
from the GC. In the first part of the configuration process, a
power and/or communication resource is assigned to the
device. The second part of the configuration process allows
setting of any configuration properties associated with the
device.
Assigning GC resources to a device
A hardware device requiring but not assigned GC resources
is given a mode of Unconfigured by the GC. Once you assign
GC resources to a device, the GC gives the device a mode of
Configured, allowing you to access other property settings (if
any) for the device.
To assign GC resources to a device with an Unconfigured
mode:
1 Unlock the GC configuration. Press [Options], select
Keyboard & Display and press [Enter]. Scroll down to Hard
Configuration Lock and press [Off/No].
2 Press [Config] on the GC keypad and select a device from
the list, then press [Enter].
The [Config] key opens a menu similar to this:
Oven
Front inlet
Back Inlet
Column #
Front detector
Back detector
Aux detector
Aux detector 2
Analog out 1
Analog out 2
Valve Box
Thermal Aux 1
Thermal Aux 2
Thermal Aux 3
PCM A
PCM B
PCM C
Aux EPC 1,2,3
Aux EPC 4,5,6
To Next Page
Loading...
Need help?
General
