316 Maintaining Your GC
16 Maintaining the G3435A/G3436A FPD
4
Disconnect the retaining spring that holds the PMT
assembly to the bracket. With a rotating motion, pull the
assembly away from the filter housing.
5 To prevent light from damaging the PMT, cap the end or
place it face down.
6 Place a clean cloth under the filter housing to catch the
filter.
• For phosphorus filter, use the sharpened wooden tip of
a toothpick or cotton swab to dislodge the filter from
the housing.
• For sulfur filter (shown below), use the wooden tip of
the cotton swab to remove the filter spacer. Then
dislodge the filter from the housing.
To Next Page
Loading...
