Agilent Technologies auroraSonata

Issue 2 - 07/00 4-65
Testing in Simulation Mode - Section 5
User to User Signalling
This service allows the subscriber to send a text message
known as User to User Information (or UUI) along with the
outgoing Call Setup request.
To check the operation of outgoing UUI, you can send a text
string within the call setup message for an outgoing test call
(this may be a self call).
Sending UUI with the Call Setup message
-1- From the Dial Options menu, select UUI.
aurora
Sonata
displays an entry window:
-2- Enter a string of characters (up to 20).
Tip
For instructions, see Entering alphanumeric information in
Chapter 2 section 3.
-3- Press the OK function key to save the string
and close the entry window.
When you make the test call (this may be a self call),
aurora
Sonata
sends the UUI along with the Call Setup request.
Checking for incoming UUI
-1- Press + 6 to display the ISDN call
information screen. For full details of this
display, see Getting information about the
current or last call in Chapter 3 section 2.
-2- Scroll down to the UUI information to check
that aurora
Sonata
has received the information.