aurora
Sonata
Hand Held ISDN Tester—User Guide
4-78 427869
When the charge information is displayed in terms of currency
rather than units, aurora
Sonata
displays CU after the value.
Sending charging information manually
When the charging Mode (see Chapter 3 section 1) is set to
Manual, you can use an aurora
Sonata
emulating an NT to send
charging information to a calling unit for an incoming test call.
To do this, in the Connected window for the call:
-1-
Press the AOC function key. aurora
Sonata
sends a
single charge unit to the caller.
ISDN sub-addressing
This service allows the subscriber to connect to terminals on a
PMP link which have the same CPN but different sub-
addresses.
Testing sub-addressing
Tip
The instructions below explain a detailed way to check the
operation of sub-addressing. For a quicker method, see Testing
services from the ISDN Test Suite later in this section.
-1-
Make a self call to another B channel of your
aurora
Sonata
, using a sub-address. aurora
Sonata
sends
an outgoing Setup message to the network,
which includes a Called Party Sub-Address ID
information element.
To Next Page
Loading...
Need help?
General
