aurora
Sonata
Hand Held ISDN Tester—User Guide
3-32 427869
Configuring the serial port/protocol output
aurora
Sonata
has a two-way, high speed RS232 serial port, which
is used to connect the tester to another device such as a PC or
printer. For example, you would connect to a PC to use
aurora
Expert
for Windows. To configure the serial port:
-1-
From the main Setup menu, select Comms/
Tracer to display the Comms/Tracer menu.
Note
The Tracer setting in this menu is used both to determine
what is output at the serial port and to select the format and
destination of the protocol decode. For more information on
protocol analysis, see Chapter 7.
Choosing the serial port output
aurora
Sonata
’s RS232 port can be used:
• to print test results
• to output results of a BERT as it is performed
• to print a protocol information from a test call
or monitor session that has been saved to
aurora
Sonata
’s memory.
• to output protocol information while a test call
or monitor session is in progress.
Note
For more information about protocol analysis, see Chapter 7.
To Next Page
Loading...
Need help?
General
