Agilent Technologies auroraSonata

Issue 2 - 07/00 5-5
Monitoring the Line
Note
When you choose Timed, a Start Time option is added to the
General Setup menu.
-4- Press ENTER to save your selection and close
the option window.
Entering an automatic start time
When you want aurora
Sonata
to begin monitoring automatically
at a certain time (Timed), you need to set the start time.
-1- From the General Setup menu, select Start
Time to display an entry window.
-2- Enter the start time in 24-hour format and
press ENTER.
Choosing the monitor output destination
Before beginning a monitor session, you can choose to send
the protocol output to the serial port during the session and
select the format in which the data is to be sent. This is
determined by the Tracer setting in the Comms/Tracer menu.
For details, see Configuring the serial port/protocol output in
Chapter 3 section 1.