Issue 2 - 07/00 2-3
Getting Started - Section 1
Preparing To Use
aurora
Sonata
This section covers information you need to know before you
start using aurora
Sonata
. It includes details about:
• connecting aurora
Sonata
and switching it on
• how to change the screen contrast and lighting
• choosing ‘hand-held’ or ‘hands-free’ operation
Connecting aurora
Sonata
Before you start, you need to connect aurora
Sonata
to an external
power source if you require one (this is usually the mains
supply). Then you need to connect to the interfaces on which
you intend to test.
Tip
You will find more information about the power sources in
Chapter 8. For details of the required voltage/frequency, see
the power supply specifications in Chapter 9 section 1.
Connecting to an external power source
-1-
Plug aurora
Sonata
’s power supply unit into a
nearby power socket which is easily accessible.
-2-
Fit its connector into the external power
supply socket on aurora
Sonata
, as shown below.
-3-
Switch on the external power source.
To Next Page
Loading...
