Issue 2 - 07/00 2-7
Getting Started - Section 1
Connecting to a PC or printer
You can connect aurora
Sonata
to a PC to send test results or
protocol information to a PC file for analysis (e.g. using
aurora
Expert
for Windows), download new software or upload/
download system settings. You can also connect to a printer to
print out test results or the protocol decode.
Note
The serial ports on both devices must be set up in the same
way. For details on how to change the configuration of
aurora
Sonata
’s serial port, see Chapter 3 section 1.
-1-
Use the RS232 cable to connect aurora
Sonata
’s
serial port to the serial port on the PC or
printer.
Tip
To check the current setup of aurora
Sonata
’s serial port, press
+ 5 to display the Status screen (see Checking the current
setup of aurora
Sonata
in Chapter 3 section 1) and look at the
Serial information.
Switching aurora
Sonata
on and off
-1- Press the key and hold it down for 1-2
seconds.
When you switch off, aurora
Sonata
stores the current system
settings and the last number (CPN) that you dialled.
To Next Page
Loading...
Need help?
General
