Agilent Technologies auroraSonata

Issue 2 - 07/00 3-3
First Steps in Testing - Section 1
Setting Up
aurora
Sonata
This section describes how to set up the way in which
aurora
Sonata
operates. It explains how to:
• set up aurora
Sonata
to operate on the ISDN
• change general settings such as the display language
• configure the serial port (these settings also
determine the format of the protocol decode)
• configure aurora
Sonata
with default settings
Note
In this Guide, settings for specific tests are covered in the same
chapters as the tests themselves. For Bit Error Rate Test
(BERT) settings see Chapter 4, and for Monitor settings (e.g.
Idle Codes) see Chapter 5.
When you first use aurora
Sonata
it may be set up with default
values or with settings downloaded from a PC.
Tip
To check the current setup, press
+ 5. For details, see
Checking the current setup of aurora
Sonata
later in this section.
To begin setting up aurora
Sonata
-1- Select Setup from the top level menu. This
displays the main Setup menu:
Note
You cannot go into the Setup menus while a call is connected.