aurora
Sonata
Hand Held ISDN Tester—User Guide
4-76 427869
-2-
Select MCID.
aurora
Sonata
displays a pop-up message to indicate whether the
MCID request has been accepted or rejected. In the case of
failure, the Cause Code is displayed.
-3-
Press On Hook ( ) to finish clearing the
call.
Note
You can also test MCID during a call. For details, see Testing
services with a connected call earlier in this section.
Advice of Charge
CorNet-T
This service allows the subscriber to display details of the
charge for a call, either during the call (AOC-D) or at the end
of the call (AOC-E).
You can use aurora
Sonata
to check the availability and operation
of call charging—for example, when addressing a dispute
between a service provider and an equipment manufacturer.
CorNet-T
When CorNet-T is selected you cannot configure aurora
Sonata
as
a NT, therefore you cannot test call charging.
If TN1R6-N and CorNet-N are selected charging information
can be generated by either the TE or NT.
Notes:
• The way in which aurora
Sonata
sends and displays charging
information is determined by the settings in the
Charging Setup menu. See Chapter 3 section 1.
TN1R6-N
• To send AOC (incoming calls), aurora
Sonata
must be
CorNet-N
emulating an NT.
• If TN1R6-N and CorNet-N are selected aurora
Sonata
can
generate charging information when it is emulating the
TE or NT.
To Next Page
Loading...
Need help?
General
