aurora
Sonata
Hand Held ISDN Tester—User Guide
5-12 427869
Changing settings while in Monitor mode
You can change some aspects of the way in which aurora
Sonata
operates without having to leave Monitor mode and go into
the Setup menus. The settings you can change are:
• the protocol and the method of voice encoding
(A-law or μ-law)
• the Idle Code that is used to determine an idle
state (absence of activity) on a channel
• the setting (on or off) for CRC4 error checking
• the configuration of the serial port
• the general setup of aurora
Sonata
—
e.g. the real
time clock setting, language of operation, etc.
• the automatic start time for monitoring.
-1-
In the main Monitor channel display, press the
Setup function key. aurora
Sonata
displays the
main Setup menu.
Note
aurora
Sonata
automatically displays only those settings that are
relevant to line monitoring. Therefore, this menu has fewer
items than the main Setup menu.
-2-
Select the type of setting you want to change:
ISDN The protocol, voice encoding method, Idle
Code or setting for CRC4 checking.
Comms/Tracer The serial port configuration.
General General settings (including the monitor start
time).
To Next Page
Loading...
Need help?
General
