aurora
Sonata
Hand Held ISDN Tester—User Guide
4-82 427869
Understanding the test results
During the test, aurora
Sonata
displays the result (Pass or Fail) for
each service. The Status bar shows which service is currently
being checked. When the test is complete, aurora
Sonata
lists the
results for all tested services.
aurora
Sonata
stores the most recent set of results for
supplementary services. You can view them by selecting Supp
Services from the Review Results menu (see section 1). The
example screen below shows a typical set of results.
Testing services using the Keypad
The Keypad facility is an alternative way to test supplementary
services. You use it to send coded requests to the network to
initiate and test the operation of specific services. The actual
codes you send depend on the network you are testing—for
details, consult the service provider.
You can use the Keypad either before connection or during a
test call.
-1-
Select Keypad from the Supp Services menu.
Note
The Keypad is available both from the Supp Services menu
which is accessed from the main Simulate menu (i.e. before
connection) and from the one which is accessed from the
To Next Page
Loading...
Need help?
General
