aurora
Sonata
Hand Held ISDN TesterâUser Guide
3-42 427869
Saving the current settings as custom defaults
Suppose you have set up aurora
Sonata
in a particular way to suit a
series of tests you are performing. However, you now need to
perform one test where the settings are different.
To avoid having to change the settings twice, you can save the
current settings, change them for the new test and then go
back to the settings you were using. To do this:
-1-
From the Set Defaults menu, select Save
Defaults. aurora
Sonata
displays a pop-up window
prompting you to confirm that you wish to
save the current settings as custom defaults.
-2-
To confirm, press the OK function key. To
cancel, press ESC.
îîNote
aurora
Sonata
stores these settings until the next time you return
to the factory defaults, even while the tester is switched off.
Returning to the custom defaults
-1-
From the Set Defaults menu, select Get
Defaults. aurora
Sonata
displays a pop-up window
prompting you to confirm that you wish to
select the custom defaults.
-2-
To confirm, press the OK function key. To
continue without changing any settings, press
ESC.
îîNote
If aurora
Sonata
does not return to your custom defaults, it is
probably because you have returned to the factory defaults
since the custom ones were set. Returning to the factory
defaults always cancels your custom defaults.
To Next Page
Loading...
Need help?
General
