106 1100 Series WS MWS Reference Manual
4 Repairing the Sampler
Introduction into Repairing the Sampler
Simple Repairs
The sampler is designed for easy repair. The most frequent repairs such as
changing a needle assembly can be done from the front of the instrument with
the instrument in place in the system stack. These repairs are described in
“Simple Repairs" on page 109.
Exchanging Internal Parts
Some repairs may require exchange of defective internal parts. Exchange of
these parts requires removing the sampler from the stack, removing the
covers, and disassembling the sampler.
Cleaning the Autosampler
The sampler covers should be kept clean. Cleaning should be done with a soft
cloth slightly dampened with water or a solution of water and a mild
detergent. Do not use an excessively damp cloth from which liquid could drip
into the sampler.
WARNING
To prevent personal injury, the power cable must be removed from the instrument
before opening the sampler cover. Do not connect the power cable to the sampler
while the cover is removed.
WARNING
Do not let liquid drip into the sampler. It could cause a shock hazard or damage to
the sampler.
To Next Page
Loading...
Need help?
General
