Repairing the Sampler 4
1100 Series WS MWS Reference Manual 155
Replacing the Autosampler Firmware
The installation of new firmware is required:
• if new version solves problems of currently installed version.
• if after exchange of the mainboard (MTP) the version on board is older than
previous installed one.
To upgrade the autosampler firmware the following steps have to be
performed:
1 Load the firmware into the autosampler, see the help system of your user
interface.
For control module see “Firmware Update" on page 269
2 If the sampler main board was replaced, re-enter the serial number
information of the module trough the user interface, see “Entering the
Serial Number using the Control Module" on page 148 or “Entering the
Serial Number using the ChemStation" on page 148.
To Next Page
Loading...
Need help?
General
