124 34410A/11A/L4411A User’s Guide
5 Specifications
These specifications apply when using the 34410A/11A/L4411A multimeter in
an environment that is free of electromagnetic interference and electrostatic
charge.
When using the multimeter in an environment where electromagnetic
interference or significant electrostatic charge is present, measurement
accuracy may be reduced. Particularly note:
• The voltage measurement probes are not shielded and can act as antennas,
causing electromagnetic interference to be added to the signal being
measured.
• Electrostatic discharges of 4000 V or greater may cause the multimeter to
temporarily stop responding, resulting in a lost or erroneous reading.
Specifications are subject to change without notice. For the latest
specifications, see the product datasheet on the Web. Firmware updates may
also be available on the Web. Start at either product page:
www.agilent.com/find/34410A
www.agilent.com/find/34411A
www.agilent.com/find/L4411A
The specifications on the following pages are valid for the Agilent 34410A, 34411A, and
L4411A multimeters with firmware revision 2.05, or later.
UG_ED5.book Page 124 Thursday, March 1, 2012 11:28 AM
To Next Page
Loading...
