68 34410A/11A/L4411A User’s Guide
2Features and Functions
Auto Triggering (34410A/11A)
This mode is available from the front panel only.
The power–on trigger default mode for the multimeter is front panel
operation, in auto trigger mode.
• Auto triggering takes continuous readings at the fastest rate possible for the
specified measurement configuration (function, range, resolution, and so
forth).
• Auto triggering is a front panel mode similar to immediate triggering from
the remote interface, but also sets the sample count to infinite and
automatically initiates continuous measurements.
• To enable auto triggering, press
TRIGGER > AUTO
Single Triggering (34410A/11A)
This mode is available from the front panel only.
• The multimeter takes one reading, or a number of readings specified by a
sample count you enter, each time you press , or upon receiving an
external trigger signal on the rear-panel Ext Trig connector (see “External
Triggering” on page 75). See also “Number of Samples per Trigger” on
page 71.
• The Trig annunciator indicates that the multimeter is waiting for a trigger.
UG_ED5.book Page 68 Thursday, March 1, 2012 11:28 AM
To Next Page
Loading...
Need help?
General
