34410A/11A/L4411A User’s Guide 97
Remote Interface Configuration 3
Setting up a LAN connection from the Remote Interface
Use the following SCPI commands to configure the LAN interface.
• To enable or disable the LAN remote interface:
SYSTem:COMMunicate:ENABle {OFF>0>ON>1},LAN
• To enable or disable the use of DHCP for the LAN interface:
SYSTem:COMMunicate:LAN:DHCP {OFF>0>ON>1}
• To enable or disable the use of Auto–IP for the LAN interface:
SYSTem:COMMunicate:LAN:AUTOip[STATe] {OFF>0>ON>1}
• To assign the LAN a static IP address:
SYSTem:COMMunicate:LAN:IPADdress “<
address
>”
• To assign a LAN Subnet Mask:
SYSTem:COMMunicate:LAN:SMASk “<
mask
>”
• To assign a LAN Default Gateway:
SYSTem:COMMunicate:LAN:GATEway “<
address
>”
• To assign a LAN Host Name:
SYSTem:COMMunicate:LAN:HOSTname “<
name
>”
• To assign the LAN a static DNS address:
SYSTem:COMMunicate:LAN:DNS “<
address
>”
• To assign a LAN Domain Name:
SYSTem:COMMunicate:LAN:DOMain “<
name
>”
Query forms of these commands are also available. Refer to the Agilent
34410A/11A/L4411A Programmer’s Reference Help for complete command
description and syntax.
If you disable or re–enable the LAN interface, you must cycle the power for the change to
take effect. You must also cylcle power when you disable or re–enable any of the LAN
services, or change any LAN settings from the remote interface using SCPI commands.
UG_ED5.book Page 97 Thursday, March 1, 2012 11:28 AM
To Next Page
Loading...
Need help?
General
