84 34410A/11A/L4411A User’s Guide
2Features and Functions
Reading the Error Queue
You can read the error queue either from the front panel, or from the remote
interface.
• Front Panel Operation: Press
UTILITY MENU > SCPI ERRORS
Scroll through the errors using the navigation keypad. Press to clear
all errors from the queue.
• Remote Interface Operation: The following command reads and clears one
error from the error queue in first–in–first–out order.
SYSTem:ERRor[:NEXT]?
Refer to the Agilent 34410A/11A/L4411A Programmer’s Reference Help for
a complete description and syntax for this command.
NISPOM Memory Sanitization
You can sanitize all user-accessible instrument memory either from the front
panel, or from the remote interface. This complies with the requirements in
chapter 8 of the National Instrument Security Program Operating Manual
(NISPOM).
• Front Panel Operation: Press
UTILITY MENU > NISPOM
Select “YES” to sanitize all user-accessible memory.
• Remote Interface Operation: The following command sanitizes all
user-accessible instrument memory.
SYSTem:SECurity:IMMediate
Refer to the Agilent 34410A/11A/L4411A Programmer’s Reference Help for
a complete description and syntax for this command.
Calibration
Only service–qualified personnel should calibrate the multimeter. Improper
use of the front–panel CALIBRATION procedure in the UTILITY menu could result in
damage to the multimeter. The multimeter is secured with a calibration
security code at the factory. Refer to the Agilent 34410A/11A/L4411A Service
Guide for calibration procedures.
UG_ED5.book Page 84 Thursday, March 1, 2012 11:28 AM
To Next Page
Loading...
Need help?
General
