Agilent Technologies N1996A-503 - Calculate:obwidth:lmask[1]|2:Trace; Calculate:obwidth:lmask[1]|2:Trace 1|2|3|4

110 Chapter 3
Mode
Occupied Bandwidth Measurement
Mode
Segment (Center, 1st or 2nd)
Selects the
Center, 1st or, 2nd segment for limit mask 1 or 2. With each segment setting, the Limits
menu is updated to show the span and level settings available for the currently selected segment
Center Segment
Segments (Center) Sets the state of the center segment to On or Off. This key is available only when
Mode SA
Remote Command :CALCulate:OBWidth:LMASk[1]|2:TRACe 1|2|3|4
:CALCulate:OBWidth:LMASk[1]|2:TRACe?
Example :CALC:OBW:LMAS1:TRAC 2
Dependencies /
Couplings
The limit mask is always displayed when the center segment is
turned on; even if the trace to which it is being applied is
blanked (‘Show’ set to Off).
Preset 1
State Saved Saved in instrument state.
Range 1 | 2
Key Path
Meas Setup, Limit Masks, Limit Mask 1, Limit Mask Trace
Mode SA
Dependencies /
Couplings
Key menu structure is dependant on selected segment.
Remote Command
Notes
The Limit Mask SCPI command syntax uses:
The keyword “CENTer” to define the Center segment level and
span.
The keyword “FIRSt” to define the 1
st
segments left and right
level and span.
The keyword “SECond” to define the 2
nd
segments left and right
level and span.
Preset Center
State Saved Saved in instrument state.
Range Center | 1st | 2nd
Key Path
Meas Setup, Limit Mask 1, Segment (Center, 1st or 2nd)