Chapter 3 47
Mode
Meas Off (Spectrum Analyzer) Measurement
Mode
Marker Trace
Assigns a marker to a trace. If a marker is currently active, press
Marker Trace until 1, 2, 3,
or
4 is highlighted. The active marker will be moved to the selected trace.
Auto Init
Turns automatic initialization On or Off. When
Auto Init is set to On the marker’s trace
attribute is re-determined automatically by the analyzer whenever the marker turns on
(Normal or Delta) from an Off state. Auto Init is set to On at
Mode Preset or Marker All Off.
The following flowchart depicts the Auto Init rules:
Key Path Marker, Off
Mode All
Remote Command :CALCulate:MARKer[1]|2|3|4:TRACe <integer>
Example CALC:MARK:TRAC 2
Dependencies / Couplings This key is only available on measurements that have
multiple traces.
Preset 1
State Saved Saved in State
Range The number of traces available to put a marker on, varies
depending on the current selected measurement.
Key Path
Marker, Marker Trace
To Next Page
Loading...
