Chapter 3 49
Mode
Meas Off (Spectrum Analyzer) Measurement
Mode
Frequency Sets the Marker Readout (Marker X Axis scale) to Frequency, displaying the
absolute frequency of a normal marker or the frequency of the delta marker relative to the
reference marker.
Period Sets the Marker Readout (Marker X Axis scale) to Period, displaying the reciprocal
of the frequency of the marker, or the reciprocal of the frequency separation of the two
markers in a delta-marker mode. In non-zero span, this is 1/frequency. The units are those
of time (s, ms, etc.).
Remote Command :CALCulate:MARKer[1]|2|3|4:X:READout
FREQuency|TIME|ITIMe|PERiod
:CALCulate:MARKer[1]|2|3|4:X:READout?
SCPI Example CALC:MARK3:X 1GHz activates the Marker3 and positions it
on the trace at 1GHz.
Remote Command Notes This feature is only available for the SA measurement in
Spectrum Analyzer Mode.
In Time Domain, only “Time” & “Inverse Time” are valid as
parameters. “Frequency” & “Period” softkey are grayed out.
“Inverse Time” is grayed out as well if the Marker Mode is not
set to Delta.
“Inverse Time” is not a valid parameter in Frequency Domain,
so the associated softkey is always grayed out.
Preset/Default Depending on the Trace Domain. If domain is Frequency,
default is Frequency; if Domain is Time, default is Time.
State Saved Ye s
Range Frequency | Period | Time | Inverse Time
Key Path
Marker, Marker Readout
Mode Spectrum Analyzer with Meas OFF
Remote Command See details in “Marker Readout (Marker X Axis Scale Type)”
Table described above
SCPI Example CALC:MARK2:X:READ FREQ sets marker 2 with a Marker
Readout type (Marker X Axis scale) to Frequency.
Dependencies /
Couplings
Only available when x axis scale is frequency.
Key Path
Marker, Marker Readout, Frequency
Mode Spectrum Analyzer
To Next Page
Loading...
