Chapter 3 75
Mode
Meas Off (Spectrum Analyzer) Measurement
Mode
Auto Trig Sets the time that the analyzer will wait for the trigger conditions to be met. If
they are not met after that much time, then the analyzer is triggered anyway. Auto Trig
defaults to off and is not accessible remotely.
Peak Search
Accesses the marker peak functions and places a marker on the highest peak of the
currently selected trace.
Next Peak
Places the selected marker on the next highest signal peak from the current marked peak.
Key Path Meas Setup, Trigger, Trig Delay
Preset 2 s, OFF
State Saved Saved in State
Min 0 s
Max 100 s
Key Path
Meas Setup, Trigger, Auto Trig
Mode: All
Remote Command :CALCulate:MARKer[1]|2|3|4:MAXimum
Example CALC:MARK2:MAX
Key Path
Front-panel key
Mode All
Remote Command :CALCulate:MARKer[1]|2|3|4:MAXimum:NEXT
Example CALC:MARK2:MAX:NEXT
Key Path
Peak Search, Next Peak, Next Peak
To Next Page
Loading...
