Chapter 3 155
Mode
Two Port Insertion Loss Measurement
Mode
06,2.14748e+06,2.14748e+06,2.14748e+06,2.14748e+06,2.14748e+06,2.14748e+06,2.14748
e+06,2.14748e+06,2.14748e+06,2.14748e+06,2.14748e+06,2.14748e+06,2.14748e+06,2.147
48e+06,2.14748e+06,2.14748e+06,2.14748e+06,0,1,0,1,0
This response is in standard block format. The above example (#45732) shows that there
are 5732 data bytes in the results string. Since this string is in ASCII, 1 data byte is
actually 1 character in the string. For example, “4.076e+00” are 9 bytes.
The response will always begin with a #, then the next number will represent the number
of digits (i.e. 4) of the “data bytes” number in the results string. This will then indicate that
the next 4 digits will be the block size, 5732 data bytes.
After this header information, you get the data in a comma separated list.
AMPTD/Y Scale
The following AMPTD/Y Scale keys are for setting up a Two Port Insertion Loss
measurement. The measurement must already be running to access these keys. Press
Meas, Two Port Insertion Loss to turn on the measurement.
Mode Stimulus Response
Remote Command :CALCulate:DATA?
Example CONF:TPIL selects the command.
INIT starts a measurement cycle.
*OPC? holds off the next command until the above
commands are complete
:CALC:DATA?
Notes You must be in the Stimulus Response mode and in the
TPIL measurement in order to get the TPIL results using
this CALCulate:DATA? query.
Remote Command Notes Agilent CSA platform does not support the READ, FETCH,
MEAS commands but offers this CALCulate:DATA?
command to get the data results of the active measurement.
Key Path
N/A. Function is only available remotely., Two Port Insertion
Loss
Mode SR
Key Path Front-panel key
To Next Page
Loading...
