28 Chapter 3
Mode
Spectrum Analyzer
Mode
Spectrum Analyzer
Selects the Spectrum Analysis measurement mode for your analyzer. This mode allows you
to make all your measurements specifying your unique setup requirements. The Spectrum
Analysis mode defaults to measurement off status. In addition, you may use the
Meas key
to select one-button measurements such as, Occupied BW (Occupied Bandwidth).
Remote Command :INSTrument:SELect SA
:INSTrument:SELect?
Example INST:SEL SA
Preset SA
Key Path
Mode, Spectrum Analyzer
Mode All
Remote Command :CONFigure:<meas_name>
:CONFigure?
:CONFigure:<meas_name>:NDEFaults
Example CONF:OBW — selects the Occupied Bandwidth measurement and
sets the instrument settings to the factory defaults.
CONF? — returns the current measurement name
CONF:OBW:NDEF — selects the Occupied Bandwidth
measurement without setting the instrument settings to the factory
defaults.
To Next Page
Loading...
