Chapter 3 45
Mode
Meas Off (Spectrum Analyzer) Measurement
Mode
Marker
Accesses the marker control keys which select the type and number of markers and turns
them on and off. Markers are diamond-shaped characters that identify points of traces. Up
to four pairs of markers may appear on the display simultaneously; only one pair can be
controlled at a time. The marker that is controlled is called the “active” marker. Pressing
Marker activates the Normal menu key.
Marker
Selects one of four possible markers. A marker that has already been turned on will
become active when it is selected. If a marker has been turned on and assigned to a specific
trace, it will become active on that trace if that marker is selected.
Notes This “Units” parameter is a Front Panel parameter only and is only
visible/accessible if the “Units” parameter is set to “Chan”.
Remote Command
Notes
No SCPI command. Front Panel only.
Range None | North American Cellular CDMA | North American PCS
CDMA | Japan CDMA | Korean PCS CDMA | Secondary 800
CDMA | IMT–2000 cdma2000 | GSM–850 | GSM–900 |
EGSM–900 | GSM DCS–1800 | GSM PCS–1900 | North
American Cellular TDMA | North American PCS TDMA |
iDEN–800 | iDEN–900 | North American Cellular AMPS |
NMT–450 | UARFCN UMTS | UARFCN Band B UMTS |
RGSM–900 | GSM–450 | GSM–480
Key Path
Frequency, Chan Std
Mode All
Remote Command :CALCulate:MARKer[1]|2|3|4:MODE OFF|POSition|DELTa
:CALCulate:MARKer[1]|2|3|4:MODE?
Preset OFF
Key Path Front-panel key
Mode All
State Saved Saved in State
To Next Page
Loading...
