Chapter 7 345
IEEE and STATus Commands (Remote Commands Only)
Standard Event Status Enable
IEEE and STATus Commands (Remote
Commands Only)
Standard Event Status Enable
Selects the desired bits from the standard event status enable register. This register
monitors I/O errors and synchronization conditions such as operation complete, request
control, query error, device dependent error, status execution error, command error and
power on. The selected bits are OR’d to become a summary bit (bit 5) in the byte register
which can be queried.
The query returns the state of the standard event status enable register.
Mode All modes
Remote Command *ESE
*ESE?
Example *ESE 36 Enables the Standard Event Status Register to
monitor query and command errors (bits 2 and 5).
*ESE? Returns a 36 indicating that the query and command
status bits are enabled.
Remote Command
Notes
For related commands, see the STATus subsystem and
SYSTem:ERRor[:NEXT]? commands.
Preset 255
Min 0
Max 255
SCPI Status Bits/OPC
Dependencies
Event Enable Register of the Standard Event Status Register.
To Next Page
Loading...
