124 Chapter 3
Mode
Occupied Bandwidth Measurement
Mode
View/Display
The display functionality is shared across all the measurements in the Spectrum Analyzer
Modes. For details about how it operates, see “View/Display (Spectrum Analyzer Mode)” on
page 87.
Remote Command Notes The query returns a name that corresponds to the detector type
as shown below, and indicates the setting for the specified trace.
The RMS selection is identical to AVERage. If RMS has been
selected, the query will return the “AVER” string.
String Returned Definition
AVER Average/RMS
POS Positive peak
SAMP Sample
NEG Negative peak
Preset Preset returns all traces to “auto” detector.
The type of detection used depends on the trace type. Since the
preset trace type is Clear/Write, the auto detector is “Sample”.
State Saved Saved in State
Range Peak | Sample | Negative Peak | Average (RMS)
Key Path
Trace/Detector, Detector Function
Mode SA
Key Path Front-panel key
To Next Page
Loading...
