Chapter 3 137
Mode
Adjacent Channel Power—ACP (I&M) Measurement
Mode
Repeat Sets the averaging function to the repeat function. Repeat averaging shows
resulting data after the selected number of sweeps has been averaged, then clears the data
before repeating the process.
NOTE While Repeat averaging is running, the results from the last completed
measurement remains on the display, the results are not updated until
the last average count has been reached.
Repeat Max Hold Sets the averaging function to repeat with max hold function. Repeat
with max hold captures and holds the highest magnitude data at the end of each sweep
count.
NOTE While Repeat Max Hold is running, the results from the last completed
measurement remains on the display, the results are not updated until
the last average count has been reached. (Maximum data points are
held with each consecutive sweep.)
Avg Number
Sets the number of measurement averages used when calculating the measurement result.
Key Path Meas setup, Avg Mode, Max Hold
Example ACP:AVER:TCON REP
Key Path
Meas setup, Avg Mode, Repeat
Example ACP:AVER:TCON RMAX
Key Path
Meas setup, Avg Mode, Repeat Max Hold
Mode Channel Analyzer
Remote Command [:SENSe]:ACPower:AVERage:COUNt <integer>
[:SENSe]:ACPower:AVERage:COUNt?
Example AVER:COUN 100
To Next Page
Loading...
