Chapter 7 351
IEEE and STATus Commands (Remote Commands Only)
Wait-to-Continue
IEEE and STATus Commands (Remote
Commands Only)
Wait-to-Continue
This command causes the instrument to wait until all overlapped commands are
completed before executing any additional commands. There is no query form for the
command.
Mode All modes
Remote Command *WAI
Example INIT:CONT OFF; INIT;*WAI Sets the instrument to single
sweep. Starts a sweep and waits for its completion.
Restrictions and Notes See related key System, Service
SCPI Status Bits/OPC
Dependencies
Not global to all remote ports or front panel. *WAI only
considers operation that was initiated on the same port as
the *WAI command was issued from.
To Next Page
Loading...
