Chapter 3 201
Mode
One Port Insertion Loss Measurement
Mode
Display Show/Blank
This key lets you make a trace visible or not. In
Blank, traces do not display nor appear on
printouts but are otherwise unaffected. They may be queried and markers may be placed
on them.
Note that the action of putting a trace in
Blank does not restart the sweep and does not
restart averaging or hold functions for any traces.
View/Display
The following View/Display keys are for setting up a One Port Insertion Loss measurement.
The measurement must already be running to access these keys. Press
Meas, One Port
Insertion Loss
to turn on the measurement.
Avg Insertion Loss
Sets the Average Insertion Loss setting to either On or Off.
Dependencies / Couplings • Setting the trace type (even to the type it was already in) puts
the trace in
Show
• Loading a trace from a file puts that trace in Show regardless of
the state it was in when it was saved.
Remote Command Notes Display On = Show, Display Off = Blank
Preset
Show for Trace 1; Blank for 2
State Saved saved in Instrument State
Key Path
Trace/Detector, Display Show/Blank
Mode Stimulus / Response
Key Path Front-panel key
Mode Stimulus / Response
Range On | Off
Key Path
View/Trace, Avg Insertion Loss
To Next Page
Loading...
